Category : DIY

So I’ve been lurking here for years sucking up info, so I figured it’s time to give something back. For those of you who like these kind of DIY write up threads here you go. Using this wiring diagram as a guide, I started splicing away! First made a little bracket to mount the controller ..

Read more

After going through a fair amount of preparation especially studying closely baysideS4’s excellent piece on much the same operation on an S4. I thought someone out there might appreciate an account of replacing the auxiliary water pump on a 2001 A6 2.7T 6-speed, with notes of a few differences and one or two alternative approaches. ..

Read more

Posted this in the quick release bumper thread and it got enough interest, so I figured id make a really quick thread briefly showing how its done. This was an after thought, so realize all images are after the install and taken with a camera phone, so use your imagination on some steps. First how ..

Read more

1. Jack up the front end and remove both wheels. If you don’t have jackstands, get some. You need to have both sides lifted so you’re not working against torsion in the sway bar. (Sorry, no pic…if this is beyond your capabilites, stop right now and get thee to a shop) 2. You’ll need to ..

Read more

Materials List: 5/16 Heater Hose 3/8 Heater Hose 5/8 x 1/2 Nylon Reducing Barb Splicer (Pref 5/8 x 3/8 if you can find it!) Hose clamps just incase XRP -10AN 45 DEG Push-on Aluminum Hose End P/N 234510 XRP Reducer, Flare -10AN to -6AN Alum P/N 991914 XRP Straight Push-on Aluminum Hose End P/N 230006 ..

Read more

Hi everyone, So I pulled the motor on my B5 S4 early this summer and had gone through a lot of the material online to get ready for it, and there was nothing really complete, every place was missing bits and pieces. So I thought that while pulling my motor I would have a checklist ..

Read more

How to Remove Audi S4 Headliner   Remove all 4 “Oh S***” handles. They are attached with two torx bit screws. Flip the cover down that covers the screw and take them out. This picture shows the cover over the torx screw: (I had already removed the handle, this is just for demonstration purposes) Here ..

Read more

Hey everyone! So I decided to do this mod after I was working on my engine and cracked the boost hose of the spider hose assembly. I didn’t realize it at the time, and couldn’t find my boost leak for a week or two (after checking every charge tube, and finally buying a set of ..

Read more

So this is the procedure to replace the more often than not faulty fresh air intake temperature sensor. Common symptoms for a faulty unit would be as follows. 1. Air conditioning compressor shuts off randomly, blowing outside temperature at you. 2. The read out temperature on your lcd screen fluctuates and is often wrong by ..

Read more

As requested, this is the write up how to install your depo ecodes. I am not responsible for any damages that may occur during install. Procede at your own risk. Tools Needed: Utility Knife Assorted Screw Drivers Drill Wire Cutters Shrink Wrap Lighter Band Saw Additional Supplies: 9006 Headlight Bulb Connectors Lexan Weather Stripping Step ..

Read more